FACE Report: Framer struck by beam after falling from scissor lift (2024)

FACE Report: Framer struck by beam after falling from scissor lift (2)

Home » FACE Report: Framer struck by beam after falling from scissor lift

Construction FACE Reports Machinery Construction

October 22, 2024

No Comments

FACE Report

FACE Report: Framer struck by beam after falling from scissor lift (7)

Case report: #71-258-2024
Issued by: Washington State Fatality Assessment and Control Evaluation Program
Date of report: Sept. 25, 2024

A 41-year-old framer had been working for two weeks a residential subcontractor at the site of a new apartment complex. The framer and a co-worker planned to use two scissor lifts in tandem to raise and insert a glulam wooden beam into the side of a horizontal I-beam more than 8 feet above the concrete floor. The beam was 22 feet long, 22.5 inches wide and 3.5 inches thick. The workers aligned the lifts about 10 feet apart and placed the beam broadside down and across the lifts’ top guardrails but did not secure it. It was about 6.5 feet above the floor. The workers were standing on the floor at opposite ends of the beam. Out of view of his co-worker, the framer unexpectedly went up the steps or climbed the side of his lift and fell on his back. The beam fell off the lift and on top of him. The co-worker saw the beam fall and ran over to lift it off the injured framer. He notified two superintendents, who called 911 and began CPR. First responders arrived and pronounced the framer dead at the scene from severe head injuries. Investigators found that the framer was not trained and authorized to use the lift, the employer and supervisor knew of the lift manufacturer’s warnings not to put materials on the guardrails and were unaware of safer options, and lift operators and helpers at the site spoke Spanish and could not read the employer’s English-only hazard assessment for the task or the incident prevention program.

To help prevent similar occurrences:

  • Use forklifts, cranes or contractor material lifts to elevate construction materials – not scissor lifts.
  • Develop and have supervisors enforce policies, job hazard analyses and standard operating procedures for safe use of elevating work platforms.
  • Have policies, JHAs and training resources translated to the worker’s preferred language.
  • Train operators using the manufacturer’s manual, and highlight warnings not to put materials on guardrails or have them exceed the confines of the guardrails unless approved by the manufacturer.

Related Articles

FACE Report: Trimmer struck by limb from storm-damaged tree

FACE Report: Machine operator fatally struck by safety block ejected from mechanical power press

FACE Report: Mechanic service technician fatally struck by order picker carriage

Post a comment to this article

Safety+Health welcomes comments that promote respectful dialogue. Please stay on topic. Comments that contain personal attacks, profanity or abusive language – or those aggressively promoting products or services – will be removed. We reserve the right to determine which comments violate our comment policy. (Anonymous comments are welcome; merely skip the “name” field in the comment box. An email address is required but will not be included with your comment.)

FACE Report: Framer struck by beam after falling from scissor lift (2024)

References

Top Articles
Latest Posts
Recommended Articles
Article information

Author: Chrissy Homenick

Last Updated:

Views: 6518

Rating: 4.3 / 5 (54 voted)

Reviews: 93% of readers found this page helpful

Author information

Name: Chrissy Homenick

Birthday: 2001-10-22

Address: 611 Kuhn Oval, Feltonbury, NY 02783-3818

Phone: +96619177651654

Job: Mining Representative

Hobby: amateur radio, Sculling, Knife making, Gardening, Watching movies, Gunsmithing, Video gaming

Introduction: My name is Chrissy Homenick, I am a tender, funny, determined, tender, glorious, fancy, enthusiastic person who loves writing and wants to share my knowledge and understanding with you.